DTS - 3-Channel C/H Receiver

LIMITED STOCK AVAILABLE!

REDUNDANT STOCK - WARRANTY EXPIRED 

NON-REFUNDABLE

1. Press and release the "Learn" push button to cycle through the output channels until the required channel is selected (indicated by the red channel LED). The Green RX LED will be on, indicating that the "Learn" mode is active. The "Learn mode is enabled for only 5 seconds. The receiver will exit "Learn" mode if there is no activity within this period.
2. With the required channel selected, press and release the remote transmitter's push button. The receiver will cancel "Learn" mode if the remote transmitter key is already programmed into the receiver memory. On reception of a valid key, the red channel LED indicator will switch off and the steady green RX LED will change to rapid flashing. A further press and release of the remote transmitters push button is required to validate the key entry (minimizes the possibility of inadvertently programming unwanted keys).
3. Successful entry and programming is indicated by one of the following methods:

• Two simultaneous flashes of the selected channel red LED and the green RX LED Indicating that a non registered key has been successfully entered and will be decoded without code hopping decryption but with serial number decoding only.
• Three simultaneous flashes of the red and green LED indicating that a registered key has been successfully entered and will be decoded with full code hopping decryption and synchronization.
• Repeat step 1 for erasing additional keys.